CAD to print
Fabrication Bench
A build log for CAD frames, print iteration, tolerance notes, failed parts, and finished assemblies.
Primary goal
Connect designed parts to fabricated reality with iteration notes.
Evidence
CAD previews, print photos, failed prints, fit checks, and change notes.
Limit
Real CAD exports and bench photos should replace the generated evidence frames.
What this mission proves
Fabrication work becomes more convincing when the page shows the distance between design intent and physical fit. The best evidence is the measured iteration: what changed, why it changed, and what the part looked like before and after.
Evidence model
This mission should eventually include CAD thumbnails, slicer settings, print photos, caliper measurements, failed-print notes, and assembly shots. The current interface leaves exact slots for those assets.
Current limit
The layout is ready, but the mission needs real media exports to become production proof rather than a structured placeholder.
Mission Timeline
Trace The Work
Each entry keeps the project inspectable by linking a system state to an evidence expectation.
Design
CAD constraints
Record mounting hole spacing, clearance assumptions, and material constraints.
Print
Fabrication pass
Capture slicer settings, print orientation, and support strategy.
Inspect
Fit check
Measure the part and record what changed for the next revision.
Archive
Failure notes
Keep warped or weak parts as evidence when they changed the design.
Evidence
Proof Slots
These cards are intentionally concrete. Replace placeholder frames with real logs, screenshots, photos, CAD exports, and code traces as they are available.
Build Stack